Post your builds

| June 28, 2016

Figure we should start a thread sharing our builds. I always like seeing new builds and getting inspiration for new ideas. -post a photo of the build -what wire is used -what size are the wraps -final ohm readings My all day everyday setup. Dual 24g 5/6 wrap around a 3mm screwdriver metering at 0.27 […]

3F Goon clone turning juice red?

| June 27, 2016

Weirdest thing. When I first got it and set it up I noticed after the first day that my coils were red and tasted odd. Thought it was just the juice. Again I ended up setting it aside for a day or 2, and now going back to it, the wick is red and the […]

Razor Clapton Coil For Cloud Chasing Super Angry Coil

| June 27, 2016

Best coil cleaning method. (Takes a little time)

| June 27, 2016

Hi I use two different mouthpieces, one type with a removable coil and one type that's sealed. Here's how I clean my coils. 1. Rinse coils with hot water 2. Soak the coils in white vinegar for 48 hours 3. Boil coils in a container for 5 minutes, 4. Dry coils with compressed air 5. […]

Raymo2u’s Build Thread

| June 27, 2016

I wanted to make a thread that I could post all of my own builds on, I will add to this thread as I go and welcome any feedback or ideas to inspire builds. Thank you for checking it out! I have sectioned off the thread in parts so it wasnt unorganized, RDA Section, TFV4 […]

ni80 wire

| June 26, 2016

So I ordered some fused claptons that were 2x 26g n80/ 36g kanthal I really enjoy the flavor but I've noticed I don't feel too well after vaping with these coils light headache/nausea Is it just me or has anyone else experienced this while vaping with these particular wires? something in my gut told me […]

Tfv8 ohms aren’t reading correct

| June 26, 2016

Hi I just put a build in my tfv8 that I got today and it's a build I always put in my rdas. Steam engine says it will come out to .12-.13 ohms and it always does on rdas. It's a 316l 25 gauge fused clapton fused with 36 gauge kanthal a1 with a 3 […]

Annealed vs Tempered Ni200

| June 26, 2016

If I'm not wanting to do any "extra stuff" to the standard coils I want to build using 26ga Ni200 for temp control, would I want Tempered or annealed Ni200? The cost is double for Tempered. Why spend the extra if I don't have to? Please tell me which I should go for with a […]

Troubleshooting assistance – coils

| June 25, 2016

I have a Subvod and have been vaping for about a week. This morning I got a really dry and nasty chemical taste in a few hits and with some research figured this means the coil needs to be changed. So I got a pack of coils at the vape shop and installed the first […]

316/n80

| June 25, 2016

Hey guys I was just wondering if I could build a clapton coil using n80 and 316ss. If I run it on power mode only will it work properly ?